IX3

Forums

My Profile

Inbox

Address Book

My Subscription

My Forums

IX3	Logged in as: Guest

arrSession:exec spGetSession 2,7,51319

	Active Users: There are 0 members and 0 guests.
	Users viewing this topic: none

Printable Version

All Forums >> [General Forum] >> Other Programming/Scripting Languages >> IX3
Do you like VisualBasicScript.com? Link to us and help spread the word about our forum. Thanks!

Page: [1]

Message

<< Older Topic Newer Topic >>

IX3 - 8/29/2007 6:21:34 AM

christic197824

Posts: 1
Score: 0
Joined: 8/29/2007
Status: offline

Hey All,

I purchased a little known program called InstantEXE (IX3) which, from what I understand, was created in VB. I am assuming, and it is apparent in many respects, that this program understands VB language in some respects.

I am trying to write an application in this program that has tree capabilities but there is not enough information out there about this program to learn from. As far as I have experimented, the application does not recognize parents, children, nodes, branches, or connectors. I am probably using them incorrectly at that.

So, I am left to use "draw" commands. IX3 contains a control panel that allows me to draw elipses, boxes, lines, and etc...When I go into the command box I am asked only to define the characteristics of the line I am drawing. There is also an input section to enter the X and Y positions, height, and length.

Does anyone know what I can enter in these boxes to tell the application to auto draw a line between Box A and Box B?

Thanks,

Christic197824